138
Select "OK" to exit the system data
The default view settings are displayed.
Arc energy in kJ
IE delivers the correct total arc energy due to the high sample measuring
rate during non-continuous welding processes.
The arc energy is total arc power during the entire welding time.
If the weld seam length is known, the electrical energy input can be cal-
culated:
E = IE / L
E Electrical energy input in kJ/cm
IE Arc energy in kJ
L Length of the weld seam in cm
The arc energy is preferably used during manual welding to calculate the
energy input.
Current motor current in A, wirefeeder 1
(wirefeeder next to the arc)
Current motor current in A, wirefeeder 2
(e.g. the rear wirefeeder in a push-pull system)
Current motor current in A, wirefeeder 3
(e.g. an unreeling wirefeeder in a push-pull system with unreeling wire-
feeder)
Current flow rate in l/min on the cooling unit
(with built-in OPT/i CU flow temperature sensor option)
Error output if flow rate < 0.7 l/min
Current coolant temperature in °C on the cooling unit
(with built-in OPT/i CU flow temperature sensor option)
Error output if coolant temperature > 70 °C
(measured at coolant return)
Current shielding gas flow rate
(with OPT/i gas controller option present)
Arc time in h
Total power source operating hours in h
4
To Next Page
Loading...
