92
** previous page: MIG/MAG pulse synergic, MIG/MAG standard synergic, MIG/MAG
PMC, MIG/MAG LSC, MIG/MAG standard manual, CMT and Job mode
Select TIG
The welding voltage is applied to the welding socket with a three second time lag.
Select "TIG welding"
The TIG welding parameters are shown.
Press the adjusting dial to change the welding parameter
The value of the welding parameter is displayed as a horizontal scale:
NOTE! Parameters that have been set on a system component control panel
(e.g. wire feed unit or remote control) might not be able to be changed on the pow-
er source control panel.
5
6
**
5
6
7
7
To Next Page
Loading...
