Fronius Virtual Welding - Scandisk

135
EN
Assign a tick to the relevant entry, depending on whether a StandUp terminal or a Mo-
bileCase is being used, by clicking on it
Touch the "Save" button to save the setting
ScanDisk ScanDisk is a program for detecting and correcting logical and physical errors on the hard
disk. This will usually make the system run more efficiently.
Touch the "ScanDisk" button
Touch the "run ScanDisk" button
Touch "Save"
ScanDisk will run the next time the Virtual Welding system is started
As long as "run ScanDisk" is selected, it will run the next time the Virtual Welding system
is started.
2
3
1
2
3
4