75
EN
Terminals
Terminals The "Terminals" function allows you to assign a predefined training course to all Virtual
Welding systems available on a network. It is possible either to assign the same training
course to all Virtual Welding systems or to assign individual training courses to specific Vir-
tual Welding systems.
Terminals - Train-
ing administra-
tion
Touch the "Terminals" button
You will then see a list of the networked terminals and, if already defined, the courses as-
signed to them.
If the same training course is to be assigned to all terminals through cluster networking:
Select "Change" next to "All terminals"
If a particular training course is to be assigned to a particular terminal within the framework
of cluster networking:
Touch "Change" next to the name of the corresponding terminal
A list of the created courses appears.
1
2
2
To Next Page
Loading...
