38
StandUp termi-
nal: Installing
system compo-
nents
On the StandUp terminal, remove the work table and allow it to engage in the holder
provided for that purpose in front of the screen
Connect the system components (1) - (3) to the connection sockets in the transitional
area between the upper and lower parts of the StandUp terminal as shown:
No. Description
(1) Workpiece holder
Connect the sensor cable to the connection socket for the workpiece sensor
(2) Headband for VR glasses
Connect the sensor cable to the connection socket for the helmet sensor or filler
material sensor
(3) Welding torch / electrode holder
Connect the sensor cable to the connection socket for the welding torch sensor
Connect the control cable to the connection socket for the welding torch control ca-
ble
If necessary, connect a LAN network cable to the connection socket (4) on the back
of the upper part.
1
2
(1)
(2)
(3)
3
To Next Page
Loading...
