70
Ghost: Adjusting
the number of
movement steps
and welding
speed
The number of steps per workpiece specifies how many defined, periodic welding torch
movements the trainee must complete in order to execute the weld seam correctly. If only
a short sequence was previously chosen as the optimal oscillation, the small number of
movement steps can now be increased up to 125. A complete weld seam can be obtained
by multiplying a short optimal oscillation.
Use the arrow keys to set the required number of steps per workpiece
Choose "Next" to save the number of steps per workpiece and move on to adjusting
the welding speed
Use the arrow keys to set the desired welding speed
The welding speed corresponds to the welding torch rate which the trainee must adhere to
in the longitudinal direction. The resulting welding time appears in the field underneath.
Choose "Next" to save the welding speed and move on to setting the stick-out
1
2
3
4
To Next Page
Loading...
