69
EN
Use the slider or arrow keys to move to the starting point of the optimal oscillation
The optimal oscillation does not have to be very long, as it can be multiplied later on to form
a complete weld seam. To obtain the required dwell times at the edges, the optimum start
and end point should be in the centre.
To define the end point of the optimal oscillation, select "Next" - the starting point ini-
tially shown in yellow turns green
Use the slider or arrow keys to move to the end point of the optimal oscillation
Select "Next" to save the end point and move on to adjustment of the number of move-
ment steps
2
3
4
5
To Next Page
Loading...
