22
different weld seam profiles in a wide variety of welding positions allows the user to broad-
en their welding skills. The visualisation shows how the weld seam is created depending
on the situation.
This means that the user always has a clear view of the results of their own work. They can
also assess their own results, put together study programmes or compete with other weld-
ers.
Proper use The device is to be used exclusively for its intended purpose.
The device is intended exclusively for the simulation of manual MIG/MAG welding and
manual metal arc welding using the hardware and software provided by the manufacturer.
Any use above and beyond this purpose is deemed improper.
The manufacturer shall not be held liable for any damage arising from such usage.
Proper use includes:
- carefully reading and following all the instructions given in the operating instructions
- studying and obeying all safety and danger notices carefully
- performing all stipulated inspection and maintenance work
- connection to the mains power supply according to the values shown on the rating
plate
- setting up in a dry and enclosed environment
- steady mounting on a firm and horizontal surface using the holders provided
The device should never be:
- modified without authorisation
- handled improperly
- operated with software other than that supplied by the manufacturer
- operated, maintained or repaired without observing the operating instructions
The device is designed for use in a dry and enclosed environment. The manufacturer is not
liable for any damage caused by use in a different environment.
The manufacturer likewise accepts no liability for inadequate or incorrect training results.
Warning notices
on the device
Warning notices and safety symbols are affixed on the StandUp terminal and on the Mobi-
leCase. These warning notices and safety symbols must not be removed or painted over.
They warn against incorrect operation, as this may result in serious injury and damage.
To Next Page
Loading...
