Fronius Virtual Welding - Controls and Connection Sockets on the Mobilecase

31
EN
Controls and con-
nection sockets
on the Mobile-
Case
The controls and connection sockets illustrated below are located on the right side panel
of the MobileCase.
No. Function
(1) VR glasses connection socket
for connecting the data cable of the
VR glasses
(2) Sensor
With an authorisation card:
Touch once:
Terminal management
Touch twice:
Setup menu
Touch three times:
Calibrate touchscreen
This necessitates holding a valid
authorisation card close to the sen-
sor (2).
NOTE!
Press the red Setup key to open the Setup menu on older systems with no sensor:
► Press once = access the Setup menu
► Press twice = calibrate touchscreen
More detailed information about "Terminal management", the "Setup menu" and "Calibrate
touchscreen" can be found in the corresponding chapters and sections of these Operating
Instructions.
No. Function
(3) External VGA connection socket
for connecting an external monitor or projector, in conjunction with a DVI/VGA dis-
tributor (43,0004,4492)
(4) USB port
for connecting the supply cable of the VR glasses (optional)
(5) LAN connection socket
for connecting a LAN network cable
(6) Connection socket for the welding torch control cable
for connecting the control cable of the welding torch
for connecting the control cable of the electrode holder
(7) Connection socket for the welding torch sensor
for connecting the sensor cable of the welding torch
for connecting the sensor cable of the electrode holder
(4) (5)(3)(2)(1)
(7)
(6)(8)(9)