Fronius Virtual Welding - Connecting the VR Glasses

41
EN
No. Description
(1) Workpiece holder
Connect the sensor cable to the connection socket for the workpiece sensor
(2) Headband for VR glasses
Connect the sensor cable to the connection socket for the helmet sensor or filler
material sensor
(3) Welding torch / electrode holder
Connect the sensor cable to the connection socket for the welding torch sensor
Connect the control cable to the connection socket for the welding torch control ca-
ble
If necessary, connect a LAN network cable to the connection socket (4).
Connecting the
VR glasses
NOTE!
The VR glasses must be connected when starting up the Virtual Welding system.
If the VR glasses are connected during operation, restart the Virtual Welding system in or-
der to initialise the VR glasses. The VR glasses can only be initialised if they are turned off
when connected.
(4)
(1)
(2)
(3)
2