Fronius Virtual Welding - Page 65

65
EN
The arrow keys next to the "Details" button can be used to select different welding param-
eters. This allows the conditions to be adapted to individual requirements.
If necessary, change the composition of the parameters using the arrow keys
Touch "Next"
If no Variable Ghost has been created, a message appears saying that no Variable Ghost
is available. Otherwise, a list of the Ghosts already created appears.
Select "New Ghost" or use an existing Ghost as a template if there is already a list of
existing Ghosts
An input window with a virtual keyboard appears in which you can enter a name for the
Variable Ghost.
Weld position
e.g.: PF
Layer
e.g.: Layer 2
Filler material
e.g.: G3 Si1 with a diameter of 1.2 mm
Power supply
e.g.: TPS 500i
Welding torch
e.g.: MTW 500i in 2-step mode
Material type / thickness
e.g.: S 235 JR with 10 mm thickness
Arc Type
e.g.: Dip transfer arc
3
4
5