5.5 Replacing Consumables
147
Maintenance
5
4
Hold the right and left levers of the
empty staple case ((1)) and remove the
case from the cartridge as shown in the
figure on the right. ((2)).
5
Prepare a new staple case. Insert the
case from its tip into the staple car-
tridge ((1)), and then push the rear of
the case until it seats((2)).
6
Hold the orange lever and push in the
staple cartridge until you hear it click
into place.
7
Close the front cover of the finisher.
A message will be displayed and the machine will not operate if the finisher's front cover is even
slightly open.
To Next Page
Loading...
