Troubleshooting
218
6
6.3
Stapler Faults
This section describes stapling troubles. Follow the procedures on the following pages when
prints are not stapled or when staples are bent. Contact our Customer Support Center if the
problem persists after you have tried the following solutions.
Stapling is available when the professional finisher (optional) and internal hard disk (optional) are installed.
If staples are stapled on the prints in the manner shown in the figures below, contact our
Customer Support Center.
Unstapled
Bent staple
One side of staple rising up Staple bent in reverse direction
Flattened staple Entire staple rising up
Staple rising up with center pressed in
To Next Page
Loading...
