5.9 Adjusting Gradation
184
Maintenance
5
To check the adjustment result, refer to Printing Chart (P.184) and print the cor-
responding chart.
Check that Low, Middle, and High density dot marks on the chart of C, M, Y, or
K, are close to those of the color sample. If you are not satisfied with the result,
do the adjustment again.
The <Process Gray> is gray obtained from a combination of C, M, and Y. If
adjustment is correctly performed, this gray will become colorless gray lick black.
If you feel that any color of C, M, or Y in Process Gray is stronger than others,
adjust that color again.
To Next Page
Loading...
