7.2 Description of Common Menu
265
Setting Common Menu
7
SMB
Set when using SMB.
â– Port Startup
Set the status of the SMB port to enabled or disabled when the power is switched on. The default is
[Enable], to use SMB.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Set the unused port status to [Disable] or change the memory allocation capacity at [Allocate
Memory], in case of insufficient memory.
â– Transport Protocol
Set the protocol of the transport levels of the SMB. You can use either NetBEUI or TCP/IP or both of
them. The default is [TCP/IP, NetBEUI].
To use TCP/IP, need to set the IP address both the computer and the machine.
â– Print Mode (LOOK 1) (P.289)
Set the process method (targeted print language) of the print data.
The optional values are as follows:
[Auto] (default)
The proper process is automatically selected according to the language of the data received from the
computer.
[PS] [ESC/P] [HP-GL/2] [PCL] [TIFF]
Data received from the computer is processed.
â– PJL (LOOK 2) (P.289)
You can use the PJL command with this printer, which does not depend on any print language. The
PJL command controls the print job, and is necessary when you use the print driver. Set the status of
the PJL command sent from the computer to enabled or disabled. By using the PJL command, you
can select the print language for the next data, even if the machine is under another process in any
print language. Set [Enable] for normal use. The default is [Enable].
â– TBCP Filter
Set the TBCP filter to enabled or disabled, while data from the PostScript is processed. The default is
[Disable].
To Next Page
Loading...
Need help?
General
