7.2 Description of Common Menu
267
Setting Common Menu
7
â– TBCP Filter
Set the TBCP filter to enabled or disabled, while data from the PostScript is processed. The default is
[Disable].
EtherTalk
Set when using EtherTalk.
â– Port Startup
Set the status of EtherTalk port to enabled or disabled when the power is switched on. The default is
[Disable]. Set [Enable] when you use EtherTalk.
If memory becomes insufficient when the port is set to [Enable], the status of the port may be automatically set
to [Disable]. Set the status of the unused port to [Disable] or change the memory allocation capacity at [Allo-
cate Memory], in case of insufficient memory.
â– PJL (LOOK 2) (P.289)
You can use the PJL command with this printer, which does not depend on any print language. The
PJL command controls the print job, and is necessary when you use the print driver. Set the status of
the PJL command sent from the computer to enabled or disabled. By using the PJL command, you
can select the print language for the next data, even if the printer is under another process in any print
language. Set [Enable] for normal use. The default is [Enable].
USB-1 (1.1)
Set to use the USB 1.1 port.
â– Port Startup
Set the status of the USB port to enabled or disabled when the power is switched on. The default is
[Disable]. Set [Enable] when you use the USB port.
Set the status of the unused port to [Disable] or change the memory allocation capacity at [Allocate Memory],
in case of insufficient memory.
â– Print Mode (LOOK 1) (P.289)
Set the process method (targeted print language) of the print data.
The optional values are as follows:
[Auto] (default)
The proper process is automatically selected according to the language of the data received from the
computer.
[PS] [ESC/P] [HP-GL/2] [PCL] [TIFF]
Data received from the computer is processed.
To Next Page
Loading...
Need help?
General
