Importan t notes
FCC Compliance Statement
If th e device c omplies with the FCC regulations, the FCC sign can be found on the type rating plate.
FCC Class B Compliance State
ment
DOC (INDU STRY CANADA) NOTICES
Notice to Users of Rad ios and Televisio n:
This class B digital a pparat us complies with Canadian ICES-003.
The following statement applies to the products covered in this manual, unless otherw ise specified
herein. The statement for other products will appear in the accompanying documentation.
NOTE:
This equipment has been tested and found to comply with the limits for a "Class B" digital
device, pursuant to Part 15 of the FCC rules and meets all requirements of the Can adia n
Interference-Causing Equipment Standard IC E S-003 for digital app aratus. T hese limits are
designed to provide reasonable protection against harmfu l interference in a residential installation.
This equipment generates, u ses and can radiate radio frequency energy and, if not installed
and used in strict accordance with the instructions, may cause h armful interference to radio
communications. However, there is no guarantee that interference will n ot occur in a particular
installation. If this equipment does cause harmful interference to radio or television receptio n,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the s
eparation b etween equipment and the receiver.
• Connect the equipment into an outlet on a c ircuit different from that to
which the receiver is connected.
• Consult the d
ealer or an experienced radio/TV technician for help.
Fujitsu is not responsible for any radio or television interference caused by unauthorized
modifications of this equipment or the substitution or attachme nt of connecting cables and
equipment other than those specified by Fujitsu. The corre ction of interference s caused by such
unauthorized modification, substitution or attachment will be the responsibility of the user.
The use of shielded I/O cables is required when connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC and ICES rules.
FCC Radiation Exposure Statement
This equipm ent complies with FCC radiation exposure limits set forth for an uncontrolled environme nt.
The transmitters in this device must not be co-located or operated in conjunction
with any other antenna or transmitter.
To prevent radio interference to the licensed service, this device is intended to be
operated indoors and away from windows to provide maximum shielding. Equipment (or
its transmit antenna) that is installed outdoors is subject to licensing.
Users are not authorized to modify this product. Any modifications invalidate the warranty.
This equipment may not be modified, altered, or changed in any way without signed
written permission from Fujitsu. Unauthorized modification will void the equipment
authorization from the FCC and Industry Canada and the warranty.
10 Fujitsu
To Next Page
Loading...
Need help?
General