Getting s tarted
Horizontal operating position with rubber/plastic feet
HorizontaloperatingpositionOperatingpos ition,horizon ta lRubber/plastic feet
The horizontal operating position is only permitted with the rubber/plastic
feet (due to the heat generated on the underside).
► If necessary, disconnect the cables.
► Place the device on its upper side on a sturdy, flat and clean surface.
► Stick the rubber/plastic feet (1) to the
underside of the casing.
► To ensure a that the device is s table,
the rubber/plastic feet should be fixed
in similar positions to the ones shown
in the illustration.
► Place the device on the rubber/plastic feet.
► If necessary, reconnect any cables that
were previously disconnected.
14 Fujitsu
To Next Page
Loading...
Need help?
General