Fujitsu ETERNUS DX100 S3 - Page 125

Chapter 1 System Management
1.8 Network Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
125
4 Click the [OK] button.
 Returns to the original screen.
5 Repeat Step 2 through Step 4 to configure several traps.
6 After adding or editing traps, click the [Set] button.
 A confirmation screen appears.
7 Click the [OK] button.
 Setting of the SNMP Agent Trap starts.
8 Click the [Done] button to return to the [Network] screen.
End of procedure
If an error screen appears under the following conditions, check the parameter settings.
• When "Manager No. " or "Community Name/User Name" is not input
• When a trap with the same parameters (except the "Trap No. ") exists
• When a trap with the same parameters (except the "Trap No. " and the "Port No. ") exists