Fujitsu ETERNUS DX100 S3 - Page 263

Chapter 3 Volume Management
3.1 Create Volume
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
263
4 Click the [Create] button.
 A confirmation screen appears.
5 Click the [OK] button.
 Volume creation starts.
6 Click the [Done] button to return to the [Volume] screen.
End of procedure
■ Manually selecting destinations to create volumes
Volumes can be created by selecting the destination manually when creating volumes under the following
conditions:
• Creating Standard, SDV, or SDPV type volumes in an existing RAID group
• Creating TPVs or NAS volumes in an existing TPP
• Creating WSVs in an existing RAID group
If an error screen appears under the following conditions, check the parameter settings.
• The "Name" is not entered
• The "Name" does not satisfy the input conditions
• The "Capacity" is not entered
• The "Capacity" does not satisfy the input conditions
• The SDPV capacity that is specified for "Capacity" is not a multiple of the SDPE capacity (1GB/2GB/
4GB)
• The number of volumes that is specified for "Number of Volumes" exceeds the maximum number
of volumes that can be created
• Free space in the RAID group is insufficient
If the NAS volume creation fails, refer to "Procedures for when the NAS volume creation is not
completed successfully" (page 257).