Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
404
(3) Manually specify the SAS address of the host to be added.
The main setting item is as follows.
● Host Setting
• SAS Address
(4) Click the [OK] button
Returns to the [Manual Input] screen.
(5) Repeat Step (2) through Step (4) to set more SAS addresses.
If an error screen appears under the following conditions, check the parameter settings.
• The "SAS Address" is not entered
• The "SAS Address" does not satisfy the input conditions
If an error screen appears under the following conditions, check the parameter settings.
• The "Host Group Name" is not entered
• The "Host Group Name" does not satisfy the input conditions
• The "Host Group Name" overlaps with an existing host group name (Host group names cannot
overlap with any other host group names, irrespective of the interface types.)
• The several SAS hosts with the same SAS addresses have been registered
• A host cannot recognize some LUNs
• Nine or more hosts are registered in the host group or no hosts are registered in the host group
• The total number of hosts has exceeded the maximum number for the ETERNUS DX
To Next Page
Loading...
