Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
411
For details on the parameters for this function, refer to "A.4.2.8 Add iSCSI Host" (page 830).
For the factory default settings for this function, refer to "Appendix B Add iSCSI Host" (page 993)
.
The procedure to register an iSCSI host is as follows:
1 Click [Add iSCSI Host] in [Action].
2 Add a host in the ETERNUS DX in the following procedures.
■ When registering a host by selecting from the host list
(1) Click the [Now Connected] tab.
All of the unregistered hosts that are connected to the iSCSI-CAs or the iSCSI-CA/RAs and that can be
recognized by the ETERNUS DX (*1) are displayed. Select the hosts that are to be registered in the
ETERNUS DX and specify the iSCSI host information.
*1: "Host that is not registered in the ETERNUS DX" indicates that a host with the same iSCSI name, IP
version, and Alias Name as the target host is not registered in the storage system. The host is regarded as
unregistered host even if a host with the same iSCSI name, IP version, Alias Name, and different IP
address is already registered. The obtained "iSCSI Name" and "Port" are displayed.
(2) Select the host that is to be registered from the iSCSI host list and input the iSCSI host information.
• To change the iSCSI host information, use the [Modify iSCSI Host] function. Refer to "4.2.16 Modify iSCSI
Host" (page 425) for details.
• The host affinity setting can be specified for each iSCSI host. Refer to "4.1.1 Create Host Affinity" (page
338) for details.
To Next Page
Loading...
