Chapter 4 Connectivity Management
4.2 Host Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
414
(4) Click the [OK] button
Returns to the [Manual Input] screen.
(5) Repeat Step (2) through Step (4) when registering several iSCSI hosts.
If an error screen appears under the following conditions, check the parameter settings.
• The "Name" is not entered
• The "Name" does not satisfy the input conditions
• The "Name" is already used for the registration target host
• The "iSCSI Name" is not entered
• The "iSCSI Name" does not satisfy the input conditions
• The "iSCSI Name" is already used for the registration target host
• The "IP Address" does not satisfy the input conditions
• The "Alias Name" does not satisfy the input conditions
• The "Alias Name" is already used for the registration target host
• The "CHAP User ID" does not satisfy the input conditions
• The "CHAP Password" does not satisfy the input conditions
• The "CHAP Password" and the "Confirm CHAP Password" do not match
• Either of the "CHAP User ID" or the "CHAP Password" has been specified
If an error screen appears under the following conditions, check the parameter settings.
• The same "Name" is already used in the ETERNUS DX
• The same "iSCSI Name" is already used in the ETERNUS DX
• The "IP Address" is specified and an iSCSI host with the same "iSCSI Name" and "IP Address" is
already registered
• The "IP Address" is not specified and an iSCSI host with the same "iSCSI Name" and "IP Version"
is already registered
• The same "Alias Name" is already used in the ETERNUS DX
• The number of hosts that is to be registered is "0"
• The number of registered hosts has exceeded the maximum number for the ETERNUS DX
To Next Page
Loading...
