Fujitsu ETERNUS DX100 S3 - Page 442

Chapter 4 Connectivity Management
4.3 CA Port Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
442
■ Setting FC Port Parameters Manually
The procedure to set FC port parameters is as follows:
Procedure
1 Select which FC port to set the parameters for (multiple selections can be made) and click
[Configure FC Port] in [Action].
2 Set the parameters for all of the selected ports.
The settings of port parameters vary depending on the port mode ("When the port mode is "CA"" (page
442), "When the port mode is "RA" or "CA/RA"" (page 443), or "When the port mode is "Initiator"" (page
443)).
■ When the port mode is "CA"
The main setting items are as follows.
● Port Settings
• Port
• Connection
• Set Loop ID
• Loop ID
• Transfer Rate
• Multiple selections can be made from FC ports that have the same "Type" and "Port Mode".
• Multiple ports can be set with the same or with different parameters in a single operation. To set
parameters to multiple ports, select the target ports and specify the parameters for each port.
After the specification is complete, click the [Modify] button.