Fujitsu ETERNUS DX100 S3 - Page 458

Chapter 4 Connectivity Management
4.3 CA Port Group Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
458
3 Select all of the copy destination ports.
The main setting item is as follows.
● Destination
• Checkbox to select copy destination port
4 Click the [Copy] button.
 Returns to the [Modify FCoE Port Parameters] screen.
5 Check the FCoE port parameters, and click the [Set] button.
 A confirmation screen appears.
6 Click the [OK] button.
 Setting of the FCoE port parameters starts.
7 Click the [Done] button to return to the [FCoE Port] screen.
End of procedure
If the parameters do not satisfy the input conditions, an error screen appears. If this occurs, check the
parameter settings.