Fujitsu ETERNUS DX100 S3 - Page 514

Chapter 4 Connectivity Management
4.8 NAS Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
514
For details on the parameters for this function, refer to "A.4.7.6 Set DNS Server" (page 895).
The procedure to set the DNS server that is used for the NAS system is as follows:
Procedure
1 Click [Set DNS Server] in [Action].
2 Specify parameters.
The main setting items are as follows.
● DNS Server Settings
• Primary IP Address
• Secondary IP Address
• IPv6 Primary IP Address
• IPv6 Secondary IP Address
3 Click the [Set] button.
 A confirmation screen appears.
To delete the DNS server settings, clear the setting fields and complete the setup.
If an error screen appears under the following conditions, check the parameter settings.
• Each parameter fails to satisfy the input conditions
• The same IPv4 address is specified for the primary IP address and the secondary IP address
• The same IPv6 address is specified for the IPv6 primary IP address and the IPv6 secondary IP
address
• The secondary IP address is specified but the primary IP address is set with a blank field
• The IPv6 secondary IP address is specified but the IPv6 primary IP address is set with a blank field