Chapter 7 Advanced Copy Management
7.8 REC Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
627
Apply Copy Path Information
In this screen, apply the copy path information.
1 Confirm that the copy path is set between the storage systems.
The checkbox is only displayed when the path information that is created by this function does not
match the path information that is already applied. Select the checkbox for path information that is to
be applied.
The main setting item is as follows.
● Remote Device Information
• Checkbox to select a Box ID
When no paths that can be applied to the storage system exist, the [Download File] screen appears.
Proceed to "Save (Save)" (page 629)
If one of the following information does not match the local storage system configuration and the
configuration in the copy path information file, the cause of the error is displayed in the [Result of
applying] screen.
• Port mode (when the local storage system is "CA" and the copy path information file is "RA")
• Port type (FC, iSCSI, and iSCSI RA)
• When the port type is "FC", the WWN information
• When the port type is "iSCSI" or "iSCSI RA", the IP address information
• When the port type is "iSCSI" or "iSCSI RA", the iSCSI name information
To Next Page
Loading...
