Appendix A Parameter List
A.4 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
886
• NFS Allowed Hosts
● Select Volume
• Radio button to select a volume
Method for inputting hosts
Specify CIFS Allowed Hosts, CIFS Denied Hosts, or NFS Allowed Hosts by using one of the following formats. If
a value other than an IP address is specified, the value is regarded as being an FQDN.
• Specifying a single host
[Example 1] 192.0.2.1
• Specifying multiple hosts
Separate each input value with a comma (0x2C).
- Specify the hosts by using IP addresses.
[Example 2] 192.0.2.1, 192.0.2.2, 192.0.2.3
- Specify the IP address and the subnet mask.
[Example 3] 203.0.113.0/255.255.255.0
Description Input all of the hosts that are allowed access to the shared folder by using the NFS
protocol.
When this parameter is omitted, access from all hosts are allowed.
To specify multiple hosts, separate each input value with a comma (0x2C). Refer to
"Method for inputting hosts" (page 886)
for details.
Input condition/
Display contents
• IP address, FQDN, or host name
• Alphanumeric characters and symbols (0x20 - 0x7E in the US-ASCII format)
(except the question mark (0x3F) and the backslash (0x5C))
• Up to 1023 characters
Note that any commas (0x2C) that are used to separate the values are also included
in the number of characters.
This item is available when "CIFS" or "CIFS/NFS" is selected as the protocol.
Description Select a NAS user volume to assign the shared folder.
Input condition/
Display contents
Radio button
• Selected
• Cleared
To Next Page
Loading...
