Appendix B Factory Default List
B.3 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
998
*1: The default value varies depending on the factory setting. Refer to "The default value for "iSCSI Name"" (page 1003)
for details.
■ Modify iSCSI Port Parameters (when the port type is "iSCSI RA (for older storage system
connection)")
■ Modify iSCSI Port Parameters ([Send Ping] screen)
■ Modify SAS Port Parameters
Screen Setting item Default value
TCP/IP Settings IP Address 192.168.xxx.xxx
Subnet Mask 255.255.255.0
MTU 1300 bytes
Security Setting CHAP OFF
General Settings Transfer Rate 1 Gbit/s
Limit Band Width 400 Mbit/s
REC Settings REC Line No. 0
REC Transfer Mode
Sync (synchronous transfer
mode)
Enable
Async Stack (asynchronous
stack mode)
Async Consistency
(asynchronous consistency
mode)
Async Through
(asynchronous through
mode)
Screen Setting item Default value
CM#x CA#y Port#z Send Number 1
Screen Setting item Default value
Port Settings Transfer Rate Auto-negotiation
Reset Scope I_T_L
Release Reservation if Chip is
Reset
Disable
To Next Page
Loading...
