Fujitsu ETERNUS DX100 S3 - Page 999

Appendix B Factory Default List
B.3 Connectivity Management
ETERNUS Web GUI User’s Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0
999
■ Modify FCoE Port Parameters
■ Modify Port Mode
■ Add LUN Group
■ Add Host Response
Screen Setting item Default value
Port Settings Transfer Rate 10 Gbit/s
Set VLAN ID Automatic
VLAN ID 0
Set Fabric Name Automatic
Fabric Name 0
Frame Size 2048 (bytes)
Reset Scope I_T_L
Release Reservation if Chip is
Reset
Disable
Screen Setting item Default value
Port List Port Mode(After) CA
Screen Setting item Default value
LUN Setting Start Host LUNs 0
Number of LUNs 1
Screen Setting item Default value
LUN Settings LUN Addressing Peripheral device addressing (Default)
LUN Expand Mode (Peripheral
Device Addressing)
Disable (Default)
ALUA Settings Asymmetric / Symmetric
Logical Unit Access
• For the ETERNUS DX8700 S3/DX8900 S3
ACTIVE/ACTIVE (Default)
• For the other models
ACTIVE-ACTIVE / PREFERRED_PATH (Default)
TPGS Mode Enable (Default)
TPG Referrals Mode Disable (Default)
Inquiry Command Settings Peripheral Device Type
(Peripheral Device Addressing)
No Device Type (3Fh) (Default)
Peripheral Device Type
(Flat Space Addressing)
No Device Type (3Fh) (Default)
SCSI Version Version6 (Default)
NACA Disable (Default)
Device ID Type Type3 (Default)
Product ID Default