DNS Server
Enable
When you set an IP address manually, specify a DNS server.
[Enable] is set to off as the factory default.
When [Enable] is set to on, specify the following items:
● Primary DNS
● Secondary DNS
Wi-Fi Diagnosis
Check the Wi-Fi connection status for the scanner.
[Diagnosis] button
The diagnosis is displayed.
Wired LAN
Configure the settings for wired LAN.
You can configure the setting when selecting [Wired LAN] for [How to connect].
IP Address
Obtain IP Address
Set an IP address for the scanner.
● Obtain automatically (DHCP)
This is the factory default setting.
● Configure manually
When [Configure manually] is selected, specify the following items:
● IP Address
● Subnet Mask
● Default Gateway
DNS Server
Enable
When you set an IP address manually, specify a DNS server.
[Enable] is set to off as the factory default.
When [Enable] is set to on, specify the following items:
● Primary DNS
● Secondary DNS
Server
Configure the settings for a server, which is to be connected to the scanner.
Scanner Settings (Touch Screen)
224
To Next Page
Loading...
Need help?
General
