Removing and installing components
during servicing
Preparing to remove components
If you are going to r emove or change system components, prepare for the removal as follows:
Please observe the safety information in chapter "Important no tes", Page 13.
Remove the power plug from the m ains outlet !
► Switch the device off.
The device must not be in energy-saving mode !
► Close the L CD screen.
► Remove all the cables from the device.
► Turn the device over and place it on a stable, flat and clean surface. If necessary, lay an
anti-slip cloth on this surface to prevent th e de vice from b eing scratched.
► Remove the battery (see "
Removing a battery", Page 54).
Fujitsu Technology Solutions 105