Working with the notebook
Key combinations
Key combinations cannot be changed.
You can find information on progra mming the tablet buttons in "
Prog ramming
the tablet buttons", P age 52.
Shortcut Meaning
4
+
A
1
Starting predefined application A
This button allows you to start a previously defined application.
By default, the button is preconfigured to start the Launch Center application.
4
+
B
2
Starting predefined application B
This button allows you to start a previously defined application.
By default, the button i s preconfigured to start the Windows Journal
application.
4
+
3
Toggle outpu t screen
Use this key combination to select which screen(s) is/are used for display if
an external monitor is connected .
Screen output is po ssible:
• only on the notebook’s LCD screen
• only on the exte rnal monitor
• both t he LCD screen and the external monitor.
Press the ke y combination several times to switch through all po ssible
settings.
If you have connect ed two e xternal monitors to the port replicator, the
following display outputs are possible:
• only on the notebook’s LCD screen
• just the external monitor (analogue)
• simultaneously on the LCD screen (d igital)
• both the LCD screen of the notebook an d the exte rnal monitor (ana logue)
You cannot switch output to both external monitors on the Port Replicator
via the key combination.
The table t button has a practical delay function: This allows you to press
the two buttons for a shortcut one after the other instead of needing to press
them bo th at the same time. After pressing the
tablet button, you have a
short time (2 to 3 seconds) to press the second button.
Fujitsu Technology Solutions 51
To Next Page
Loading...
Need help?
General