Security functions
SmartCard SystemLock (optional)
With SystemLock enabled, the device can only be started using an initialised SmartCard (SICRYPT,
CardOS or Fujitsu) and a personal identification number (PIN). The SmartCard and PIN are
checked during system booting in the BIOS, i .e. before the operating system is started.
SmartCard SystemLock
Item Specific Help SmartCard SystemLock Not Installed
Install Single PC:
[Enter]
Install Group PC: [Enter]
Installs the security
for this PC, and
creates a new
SystemLock Admin
SmartCard dedicated to
this PC.
SmartCard data will be
overwritten.
A correct SmartCard is
required for a
permanent installation
SmartCardSwitchingonthe
system
All new SmartCards h ave a preset P IN (Personal Identification Number)
and PUK ( Pe rsonal Unblocking Key).
On SIC RYPT and CardOS SmartCards, the value 12345678 is preset
for the PIN and the PUK.
On Fujitsu cards, the value 0000 is preset for the PIN and the value
administrator is preset for the PUK. For security reasons, we recommend
that you change both P IN and PUK w ithout fail.
Additional software (e.g. Smarty) is required so tha t the system can also c heck that
the correct SmartCard is inserted while the s ystem is ru nning.
You will find information on how to uninstall SystemLock under "Uninstalling SystemLock".
A system w hich was protected using SystemLock can no longer be released.
Always create a backup copy of the SmartCard which was used.
Fujitsu Technology Solutions 83
To Next Page
Loading...
Need help?
General