Security functions
Switch on the device using Syste mLock
If you have an internal SmartCard reader, you can switch on the device by inserting the SmartCard.
If you switch on the device with the On/Off switch then the following message appears:
Insert a SmartCard.
SystemLock
► In sert your SmartCard.
Enter PIN:
► Enter your PIN.
When the following appears:
• ACCESS DENIED = You have entered an incorrect PIN. After three failed attempts, the
SmartCard will be blocked and can only be enabled again by entering the PUK.
Depending on the rights assigned to your SmartCard, you can select the following
functions when this message is displayed on the screen:
F2=Setup, F3=Change P IN
If your SmartCard has the appropria te rights, you can:
F2,function keyF3, functionkey
F2
: start BIOS Setup.
F3
: change PIN.
If you do not select a function, the system will boot up.
Start BIOS Setup
F2
A S martCard with the appropriate rig
hts m ust be inserted (SuperUser, Service or Admin).
Changing PIN
It is possible to change the PIN fo r any initialised SmartCard.
► Press th e function key
F3
.
► Ente r the old PIN.
► Ente r t he new PIN.
A number with 4 to 8-digits is acceptable fo r the new PIN. For security
reasons, we recommend that you change the PIN for every SmartCard,
and use an 8-digit number each time.
► Confirm the new PIN.
Uninstall Sys temLock
► Start the device.
Uninstalling
► F ollow the instructions given in sect ion "Carrying out administrator function s",
Pag e 91. Select "Uninstall" to uninstall SystemLock . You can now use the
device again without the need for a SmartCard.
94 Fujitsu Technology Solutions
To Next Page
Loading...
Need help?
General