Fujitsu Primergy BX900 S2 - Single-Width Connection Blades; Installing Single-Width Connection Blades; Required Tools; Preliminary Steps

To Next Page

To Previous Page

112 Upgrade and Maintenance Manual BX900 S2

Connection blades

The configuration of the connection blade is controlled by the management

blade. Each port group can be configured to a certain link protocol. The

management blade web interface allows the user to modify the port group link

speed configuration.

8.2 Single-width connection blades

8.2.1 Installing single-width connection blades

8.2.1.1 Required tools

● Preliminary and concluding steps: tool-less

● Installing connection blades: tool-less

8.2.1.2 Preliminary steps

Before installing a single-width connection blade, perform the following steps:

Ê If applicable, open the rack door as described in section "Opening the rack

door" on page 48.

Ê Locate the desired system unit as described in section "Determining the

error class" on page 45.

Ê Locate the mounting bay for the new connection blade using the information

in section "Connection blade fitting rules" on page 106.

Upgrade and Repair Units (URU)

average hardware task duration: 5 minutes

average software task duration: 10 minutes

Other manuals for Fujitsu Primergy BX900 S2