BX900 S2 Upgrade and Maintenance Manual 155
Local Service Display
Figure 54: Fastening the Local Service Display stop
Ê Fasten the Local Service Display Secure stop using the screw that you kept
when you removed the defective one.
10.1.5 Concluding steps
Perform the following procedures to complete the task:
Ê Reconnect the AC power cord to the PSUs and secure it with a cable tie as
described in section "Connecting the system unit to the mains" on page 50.
Ê If applicable, close the rack door as described in section "Closing the rack
door" on page 60.
Ê Switch on the system unit as described in section "Switching on the system
unit" on page 52.
/
To Next Page
Loading...
