Fujitsu Primergy BX900 S2 - 5 Basic Software Procedures; Starting the Maintenance Task; Switching on the ID Indicator

BX900 S2 Upgrade and Maintenance Manual 63
5 Basic software procedures
5.1 Starting the maintenance task
5.1.1 Switching on the ID indicator
When working in a datacenter environment, switch on the ID indicator on the
front and rear of the system unit for easy identification.
I For further information, refer to section "Locating the defective system
unit" on page 45.
Using the ID button on the Local Service Display
Ê Press the ID button on the Local Service Display to switch on the ID
indicators.
I For further information, refer to section "Control elements on the
Local Service Display" on page 180.
Using the ID button on the management blade
Ê Press the ID button on the management blade to switch on the ID indicators
I For further information, refer to section "Control elements and
indicators on the management blade" on page 184.
Using management blade web interface
Ê In management blade web interface press the Locate button in the status
frame to switch on the ID indicators.
Using ServerView Operations Manager
Ê In ServerView Operations Manager choose Single System View and press the
Locate button in the title bar to switch on the ID indicators.