94 Upgrade and Maintenance Manual BX900 S2
Power supply
© cognitas. Gesellschft für Technik-Dokumentation mbH 2011 Pfad: C:\Programme\FCT\tim_app\tim_local\work\WALTER\OBJ_DOKU-13656-001.fm
6.2.3 Installing a power supply unit
Figure 14: Open release lever
Ê Open the release lever (1).
Ê Push the PSU as far as possible into the empty bay (2).
Ê Swivel the release lever down until it clicks into place under the locking lever.
6.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê Connect the AC power cord to the PSU and secure it with a cable tie as
described in section "Connecting the system unit to the mains" on page 50.
Ê If applicable, close the rack door as described in section "Closing the rack
door" on page 60.
Ê Configure PSU redundancy as described in section "Configuring power
supply redundancy" on page 81.
/
0
To Next Page
Loading...
