Fujitsu Primergy BX900 S2 - Installing a Connection Blade Dummy Module; Concluding Steps; Replacing Single-Width Connection Blades; Required Tools

BX900 S2 Upgrade and Maintenance Manual 117
Connection blades
8.2.2.4 Installing a connection blade dummy module
Figure 25: Installing a dummy connection blade module
Ê Push the connection blade dummy module into the slot until the handles
click into place.
8.2.2.5 Concluding steps
Perform the following procedures to complete the task:
Ê If applicable, close the rack door as described in section "Closing the rack
door" on page 60.
8.2.3 Replacing single-width connection blades
8.2.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing connection blades: tool-less
Upgrade and Repair Units (URU)
average hardware task duration: 5 minutes
average software task duration: 10 minutes