Fujitsu Primergy BX900 S2 - Removing a Single-Width Connection Blade

116 Upgrade and Maintenance Manual BX900 S2
Connection blades
© cognitas. Gesellschft für Technik-Dokumentation mbH 2011 Pfad: C:\Programme\FCT\tim_app\tim_local\work\WALTER\OBJ_DOKU-13659-001.fm
Ê Save the connection blade settings as described in section "Saving
connection blade settings" on page 76.
Ê If applicable, open the rack door as described in section "Opening the rack
door" on page 48.
Ê Locate the desired system unit as described in section "Determining the
error class" on page 45.
Ê Locate the desired connection blade as described in section "Locating the
defective component" on page 48.
Ê If applicable, disconnect cables from the connection blade.
Ê If applicable, remove SFP transceiver modules from the connection blade as
described in section "Removing an SFP+ transceiver module" on page 133.
8.2.2.3 Removing a single-width connection blade
Figure 24: Removing a connection blade
Ê Unlock the locking lever (1) and open the release lever (2).
Ê Carefully remove the connection blade from its slot.
/
0