175
PRIMERGY RX300 S4 User's Guide
11 Pull the SAS cable through the side of the device and attach the cable cover
that was removed in Step 5.
12 Attach the fan cage and all the fans.
To attach them, simply perform the removal procedure in reverse.
13 Install the internal hard disk unit and the dummy units.
To attach them, simply perform the removal procedure in reverse.
14 Attach the USB unit that was removed in Step 7 to the front of the server.
Push it until it is all the way seated. It automatically locks.
15 Attach the fan duct.
" How to attach the fan duct" (p.138)
16 Attach the top cover, and push the server back into the rack.
" How to attach the top cover" (p.137)
How to remove the internal backup device
To remove the internal backup device, simply reverse the installation procedure.
To Next Page
Loading...
