48
Chapter 2 Checking before OS Installation
Adapter numbers
For ServerStart, onboard multiple LAN adapters (network adapter) may be configured on OS
installation wizard.
To configure multiple LAN cards, select the adapter numbers in order of Adapter 1 and Adapter 2, and
enter settings for each adapter. Note that the order of adapter numbers is not necessarily the same as the
order of slots for the installed LAN adapters. This means that the setting for Adapter 1 is not always
applied to the onboard LAN. After installing the OS, check the LAN adapters to make sure that they are
configured as intended.
Setting up the printer
ServerStart does not support setup of printers. Perform installation after setup is completed.
2.3.4 Automatic Driver Installation with ServerStart
ServerStart supports automatic driver installation for the following expansion cards.
table: Automatic Driver Installation
Onboard controller/Card type Product ID Bus
Onboard FDD/IDE - -
Onboard LAN -
PCI-E
Onboard VGA - PCI
SAS RAID Ctrl PG-248G2L/PG-248CL/
PG-244CL
PCI-E
SAS Ctrl PG-228BL PCI-E
Eth. Ctrl 1000-BASE-SX Fibre LC lp
PG-1882L PCI-X
Eth. Ctrl 1000-BASE-T Cu lp PG-1892L PCI-X
Eth. Ctrl 1x1Gbit PCI 1000-BASE-T lp
PG-1853L
PCI-X
Eth. Ctrl 2x1Gbit PCI-X 1000-BASE-T lp
PG-1863L
PCI-X
Eth. Ctrl 1x1Gbit PCI-E 1000-BASE-T lp PG-289L
PCI-E
Eth. Ctrl 1x1Gbit PCI-E 1000BASE-SX lp
PG-288L PCI-E
Eth. Ctrl 2x1Gbit PCI-E 1000-BASE-T lp
PG-2861L PCI-E
SCSI Ctrl U320 lp
PG-2281L PCI-E
Fibre Channel Controller PG-FC202 PCI-E
To Next Page
Loading...
