201
PRIMERGY RX300 S4 User's Guide
When rebooting after the settings of the [Change TPM State] item is changed, the BIOS Setup Utility
may start up after POST finishes.
In this case, select the [Physical Presence operations] submenu, and perform [Execute] in the
following displayed window. The settings will be enabled.
Phoenix TristedCore(tm) Setup Utility
Item Specific Help
Select Item
Select Menu
Change Values
Execute Command
-/+
Enter
TPM configuration change was requested to
State: Enable & Activate
Note:
This action will switch on the TPM
Reject
Execute
Physical Presence operations
F10
Save and Exit
To Next Page
Loading...
