254
Appendix
3 When "Please enter pass phrase" appears, enter the password and press the
[Enter] key.
Note that the password is case-sensitive. As shown below, the characters you have entered are
displayed as asterisks.
The remote control [Main] menu appears.
4 Press the [2] key and select "Power Management".
The [Power Management] menu appears.
Please enter pass phrase: *****
****************************************
* Welcome to PRIMERGY Remote Manager *
* Firmware Revision x.xxA (x.xx) *
* SDRR *.** ID 0203 RX300S4 *
* Firmware built xxx xx xxxx xx:xx:xx *
****************************************
System Type : PRIMERGY RX300 S4
System ID : xxxxxxxx
System Name : RX300S4-2 (xxx.xxx.xxx.xxx)
System OS : xxxxxxxx
System Status: OK
Power Status : On
Main Menu
(1) System Information...
(2) Power Management...
(3) Enclosure Information...
(4) Service Processor...
(c) Change password
(r) Console Redirection (EMS/SAC)
(s) Start a Command Line shell...
Enter selection or (0) to quit:
****************************************
* Welcome to PRIMERGY Remote Manager *
* Firmware Revision x.xxA (x.xx) *
* SDRR *.** ID 0203 RX300S4 *
* Firmware built xxx xx xxxx xx:xx:xx *
****************************************
System Type : PRIMERGY RX300 S4
System ID : xxxxxxxx
System Name : RX300S4-2 (xxx.xxx.xxx.xxx)
System OS : xxxxxxxx
System Status: OK
Power Status : On
Power Management Menu
(1) Immediate Power Off
(2) Immediate Reset
(3) Power Cycle
(*) Power On
(*) Graceful Power Off (Shutdown)
(*) Graceful Reset (Reboot)
Enter selection or (0) to quit:
To Next Page
Loading...
