34
Chapter 1 Overview
Cautions when handling media
• When removing a disc from its case, press the central disc holder to release the disc as shown in the
figure below, then just lift the disc up.
• Hold CDs/DVDs by their edges to avoid contact with the disc surface.
• Do not contaminate the CD/DVD surface with fingerprints, oil, dust, etc. If dirty, clean with a soft,
dry cloth, wiping from the center to the edge. Do not use benzene, thinners, water, record sprays,
antistatic agents, or silicone-impregnated cloth.
• Be careful not to damage the CD/DVD surface.
• Keep the CDs/DVDs away from heat sources.
• Do not bend or place heavy objects on CDs/DVDs.
• Do not write with ballpoint pen or pencil on the label (printed) side.
• Do not attach stickers or similar to the label side. Doing so may cause rotational eccentricity and
abnormal vibrations.
• When a CD/DVD is moved from a cold place to a warm place, moisture condensation on the CD/
DVD surface can cause data read errors. In this case, wipe the CD/DVD with a soft, dry cloth then let
it air dry. Do not dry the CD/DVD using devices such as a hair dryer.
• To avoid dust, damage, and deformation, keep the CD/DVD in its case whenever it is not in use.
• Do not store CDs/DVDs at high temperatures. Areas exposed to prolonged direct sunlight or near
heating appliances are to be avoided.
Inserting the CD/DVD
1 Make sure the server is turned on and press the CD/DVD eject button.
The CD/DVD tray comes out a little.
CD/DVD eject button
To Next Page
Loading...
