53
PRIMERGY RX300 S4 User's Guide
5 Set configuration of the RAID and disks and click [Next].
To install the OS while maintaining the established RAID environment
Select [Logical Disk 0] and specify partition size to be created.
One partition can be created. Select [Logical Disk 0] even if the RAID is not required to be
created.
To configure RAID
Select [create new RAID array with one partition] and specify the RAID level to be configured
and the size of the partition.
All existing RAID will be deleted. Also, only one partition can be created.
When [Auto] is selected, the RAID is configured with the following levels, depending on the
number of the installed disk units.
• When two hard disk units are installed: RAID1
• When three hard disk units are installed: RAID5
• When more than three hard disk units are installed: RAID5 with hot spare function
The configurations of the created partitions are as follows.
• Volume label: system
• File system: NTFS
• Partition configuration: Boot/OS
The [Please select the OS to install] window appears.
To Next Page
Loading...
