178
Chapter 7 Installing Hardware Options
5 Remove the front cover.
1. The front cover is fastened with two stoppers. Pull the stoppers to remove at the
bottom of the server.
2. Lift the front cover upward to remove.
Remove the front cover as necessary, e.g., when you install a 5-inch internal device.
■ Installing Covers
To attach covers, simply reverse the removal procedures.
• Before turning on the server, make sure that all covers are in place.
• Check to make sure no tools or unnecessary components are left inside the
server before attaching the side cover back into place.
Stoppers
To Next Page
Loading...
