1. OPERATIONAL OVERVIEW
1-5
Note 1: The default settings for night mode is 6 for [Display] and 7 for [Panel]. If the
display is difficult to see when switching to the night mode, use the cursorpad (X) to
increase the display brilliance.
Note 2: Whenever the brilliance mode is changed, the last-used brilliance for the se-
lected mode is set.
Note 3: When the brilliance is preset, the background color is also preset (see
paragraph 2.1.1). So both the brilliance and the background color are restored to the
default when long-pressing the key.
1.4 How to Select the Display Mode
There are five display modes: PLOTTER, INTEGRITY, HIGHWAY, COURSE and DA-
TA. Press the DISPLAY key to select the display mode, in the following sequence. To
reverse the order, long-press the DISPLAY key.
You can turn off the highway, course or data display if its use is not required.
1. Press the MENU/ESC key to open the main menu.
2. Select [1 Display] then [9 Display Select].
3. Select [3 Highway], [4 Course] or [5 Data].
4. Select [1 On] or [2 Off]. The display modes which are set to off are skipped when
operating the DISPLAY key.
Note: The plotter and integrity displays can not be disabled.
5. Press the MENU/ESC key to close the main menu.
The data is arranged according to data type.
*: The alert information is displayed when an alert occurs.
PLOTTER INTEGRITY HIGHWAY
COURSEDATA
: Short-press the DISPLAY key
: Long-press the DISPLAY key
Common information
Main information
Guidance or
alert information*
Mode
To Next Page
Loading...
