4. ROUTES
4-10
How to erase a waypoint with the ACK/DELETE key
1. Press the CURSOR ON/OFF key to turn the cursor on.
2. Use the cursorpad to select the waypoint to delete then
press the ACK/DELETE key. The confirmation message
appears.
3. Select [1 Yes].
How to erase a waypoint from the route list
1. Press the MENU/ESC key to open the main menu.
2. Select [3 Navigation] then [2 Route Registration].
3. Use the cursorpad (S or T) to select the route no. which contains the waypoint
to delete then press the NU/CU ENT key.
4. Select [6 WPT List].
5. Use the cursorpad (S or T) to select the waypoint to delete then press the NU/
CU ENT key.
6. Select [0 Delete].
7. Press the MENU/ESC key to close the main menu.
4.2.5 How to insert a waypoint in a route
You can insert a waypoint backward or forward of the selected waypoint in a route. For
example, to insert a waypoint backward or forward of "POINT0003", do the following:
1. Press the CURSOR ON/OFF key to turn the cursor on.
2. Use the cursorpad to select the waypoint (in this example, "POINT0003") then
press the key to open the context menu.
3. Select [9 Insert].
4. Select [1 Forward] or [2 Back].
[Forward]: Insert a waypoint forward of the selected waypoint.
[Back]: Insert a waypoint backward of the selected waypoint.
5. Select [1 Cursor], [2 Input L/L] or [3 From Mark List].
6. Set a waypoint position refer to paragraph 4.1.3. The context menu closes after
selecting [9 Add].
POINT0001
POINT0005
POINT0003
POINT0002
POINT0004
“Back” when
selecting [2 Back].
To Next Page
Loading...
